Telnet commands to change ip of hp jetdirect 170x

#Telnet commands to change ip of hp jetdirect 170x Patch#

Use the / to verify the changes you have made. ( the charactors you type will not be displayed as you type them but will be sent to the print server when you hit enter. Telnet 192.0.0.192 from a command prompt. remember that most commands are lower case and the settings are uppercase. 192.0.0.19, port 23, TCP/IP (winsock), and under settings-ASCII setup-check echo typed charactors locally. Create a connection using hyperterminal. (remember, Change the TCP/IP settings after all other changes have been applied.)(this is the simplest for configuring the print server but is subject to browser settings.) Use 192.0.0.192 as the url in your browser, then configure the settings using this interface. for the print server to complete it's initial configuration. While holding down the test button Apply power to the print server. Now reset the Print server to it's default values.

Temporarily change the computers IP address to 192.0.0.1. (It's best if you are not on the network yet depending on your configuration) Connect the printer to the print server and then to the computer that you are going to use to configure the print server.

#Telnet commands to change ip of hp jetdirect 170x Patch#

You will need a crossover network cable or a hub and two patch cords to connect a computer directly to the print server. JxxxxB the A revision has certain issues but may work depending on your network setup. If you have the 170X with the b revision it will work with this printer.